![]() ![]() This is a picture showing the gap at the bottom of the panel filled with some kind of filla -> I've included some pictures below showing his work:. ![]() I wanted to check and ask when you fit a kitchen working surface is it normal practice to leave gaps at the back and not seal them, and the kick back boards at the bottom of the units also have gaps and I not sure if these should have been sealed or filled. Theyve left the drain pipe for the sink sticking out and its not attached to the wall. They haven't left a big enough gap for the fridge so it sometime difficult to open. ![]() When Currys tried to install my dishwasher they advised that the kitchn unit wasn't staright and it couldn't be fitted. When i've checked the kitchen i've found that their were gaps at the back on the working surfaces which were not filled or sealed, some of the side panels to on the kitchen cupboards have been filled with filler at the bottom. I've recently had a new kitchen install which was done by one of the big companies and cost me a lot of money, I went with one of the big trades companies as I thought they would only employ high quality trades people. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |